Airless spray application shall be in accordance with the following procedure:
as per steel structure paint Manual Vol.1 & Vol.2 by SSPC, USA, Air less spray relies on hydraulic pressure rather than air atomization to produce the desired spray. An air compressor or electric motor is used to operate a pump to produce pressures of 1000 to 6000 psi.
Paint is delivered to the spray gun at this pressure through a single hose within the gun. A single paint stream is divided into separate streams, which are forced through a small orifice resulting in atomization of paint without the use of air. This results in more rapid coverage with less over spray.
Airless spray usually is faster, cleaner, more economical and easier to use than conventional air spray.
Pipe Spray Painting Machine is mounted on wheels, and paint is aspirated in a hose that sucks paint from any container, including drums. The unit shall have inbuilt agitator that keep the paint uniformly mixed during the spraying. The unit shall consist of inbuilt strainer. Usually very small quantities of thinning are required before spray. In case of High Build Epoxy coating (two pack). 30:1 pump ratio and 0.020-0.023” tip size will provide a good spray pattern. Ideally fluid hoses should not be less than 3/8” ID and not longer than 50 ft to obtain optimum results. In case of gun choking, de-choking steps shall be followed immediately.
What Are Spray Painting and Powder Coating?
Spray Steel Pipe Painting Production Line is the process of applying liquid paint using pressure. This can be done in one of three ways:
Conventional high-pressure spraying
High-volume low-pressure (HVLP) spraying